REAR WINDOW SEALS FOR JAGUAR XJ SERIES 1968 - 1979

REAR WINDOW SEALS FOR JAGUAR XJ SERIES 1968 - 1979

*NEW*

*Please note the image is an example for illustrative purposes and the rubber you order is tailored for your vehicle.

We endeavour to keep stock levels as accurate as possible. However, due to the fact we sell both online and in-store, there may be slight inconsistencies in these stock levels. To confirm stock levels, please get in touch

The seal is really 2 pieces with the trim sandwiched between them. These are not really seals but finishing pieces for the stainless trim.
The inner (glass side) seal is independent of the outer (body side) seal.

Locate the joint on the inner seal and slowly pull toward the glass side.
Locate the joint on the outer seal and slowly pull toward the body side.

If you try pulling the seals toward the stainless steel trim you may bend it and if you do, it will never sit right again.
You may find that when trying to remove the inner and outer seal it may be stuck with some of the windscreen adhesive. Just take your time and carefully cut away the adhesive.
After removing the inner and outer seal, carefully cut away the stainless steel trim from the adhesive. Carefully clean trim for installation.

When removing the front and rear glass, the OEM seal was just held by the adhesive in a few spots.
The seals are normally loose around the lower corners. That is where water enters and rot the corners of these cars.
After removing the 2 seals and the stainless trim, there will be the real seal and adhesive that attaches the glass to the body of the car.

Happy Installing!